奥德高温模温机安装及注意事项
Chapter Five Installation and Precautions
安装注意事项 (Installation and Precautions):
1 本机仅可使用机箱铭牌的标示之三相电压及频率，地线必接。
The equipment can only use the three-phase voltage and frequency that are stated on the nameplate on the cabinet; the earth wire must be connected to the ground.
2 外部配管的选择（External Pipe Selection）：
名称 Name | 使用温度 Working Temperature | 适用时间 Tool Life |
棉纱管 cotton yarn pipe | 60℃ | 约半年 about half a year |
中压皮管 mid-pressureleather pipe | 120℃ | 约一年 about one year |
铁氟龙管 Teflon pipe | 200℃ | 约一年 about one year |
波纹管 ripple pipe | 350℃ | 约一年 about one year |
注：管路的寿命也可能因环境影响而造成；冷却水出口处温度比较高，冷却水出口应使用铁氟龙管，热油进出口应使用波纹管连接。
Notes：The pipe service life may be related to the environment. Teflon pipe should be used in the cooling water outlet due to the higher temperature，and ripple pipe should be applied in the hot oil inlet and outlet.
3 导热油的选用 (Heat Transfer Oil Selection)：
描述 Description | 型号 Model | 温度 Temperature |
首诺Mobil | 首诺 T55 | 300℃ |
美孚 Mobil | 美孚603 Mobil 603 | 200℃ |
美孚 Mobil | 美孚605 Mobil 605 | 300℃ |
油的特性是不可以混合使用的，否则会产生油泥，造成堵塞。
Different oil cannot be mixed, or there will be oil sludge and consequent blockage.
请每期定时更换干净的循环油，若长时间使用在150℃以上时，每三至六个月检查导热油，根据实际情况决定是否更换。
Please change the circulating oil regularly. In case of long-term use above 150℃，change the oil every 3 to 6 months，Decide if replace according to the physical truth.
更换循环油时，勿让水或异物掉入油箱内。
When changing the circulating oil，don’t drop water or impurities into the oil tank.
